Connect IP cameras to the PC

Prerequisite

You have followed the entire procedure in Ethernet card setup

Procedure

The procedure applies to a Cisco  SG 100D 8 port Gigabit PoE-switch, which is supported with MediaRecorder.

Using cross-network cables (cat-5e or newer), connect the Ethernet card on the PC to one of the four right ports of the PoE-switch.

  1. Connect the camera to one of the four left ports of the PoE-switch. Do not use any of the four right ports for this purpose, since they do not supply your cameras with power.
  2. Power up the PoE-switch.

image.png

Notes

See Power over Ethernet in Recording devices


Revision #6
Created 1 December 2023 08:37:47
Updated 2 January 2024 19:52:25