Recently Updated Pages
How Viso annotations appear in The Observer XT
In the Coding Scheme In The Observer XT, choose Setup > Open Coding Scheme, to open the Coding S...
Playback events
If you want to play back a specific event, set a pre-roll interval to start playing a few secon...
Scheduler
The Scheduler tab is available if you have the Scheduler Module. In this tab you can schedule you...
Introduction
Viso® is a powerful tool to record video and audio in multiple independent locations. Record with...
Set up the Epiphan Pearl Nano screen capture device
Aim To connect the Epiphan Pearl Nano screen capture device and make the necessary settings. ...
Select devices that do not support ONVIF in MediaRecorder
Aim To select a device that does not support ONVIF Profile S in MediaRecorder. If your device d...
Screen capture devices
When do I need a screen capture device? You can easily record what your test participant is doin...
Epiphan screen capture devices
Supported devices MediaRecorder supports Epiphan Pearl Nano. This is an encoder device that is a...
Supported devices for The Observer XT - portable set-up
The table below shows the maximum supported (1) resolution, (2) frame rate (fps), (3) number of d...
Supported devices for The Observer XT - stationary set-up
The table below shows the maximum supported (1) resolution, (2) frame rate (fps), (3) number of d...
Supported devices for EthoVision XT
The table below shows the maximum supported (1) resolution, (2) frame rate (fps), (3) color space...
Supported microphones
Ceiling microphone Ceiling microphones are omni directional and are suitable for both speech as ...
Important concepts in audio
Preamplifiers The signal from a microphone is of low voltage. This signal needs to be amplified ...
Which audio device should I use?
The appropriate audio device depends on your setup. Take the following rules of thumb into accoun...
Configure the Basler USB 3 camera
Aim To adjust settings in the USB 3 camera, like the video frame rate, resolution, and exposure....
Connect the USB 3 cameras to the PC
Connect the cameras to the USB 3 interface card of the MediaRecorder computer. TIP USB 3 conn...
Install the USB 3 camera driver
Aim To install the software that allows communication between your camera and the operating syst...
The steps to install USB 3 cameras
Prerequisite You have USB 3 cameras that supported with MediaRecorder. See Supported USB camera...
Configure the cameras
Aim To adjust settings in a Basler GigE camera or USB 3.0 camera, like the video frame rate, vid...
Set camera IP address
Aim To make sure that the IP address of the GigE camera and that Ethernet interface board physic...